Why is stainless steel wire mesh made into backwash equipment?

With the development of industry, the situation of water pollution is very bad, so how should we deal with such a situation? Next we will introduce to you about self-cleaning stainless steel wire mesh, I hope you can understand why stainless steel wire mesh made into backwash equipment? First of all, the use of self-cleaning stainless steel wire mesh self-cleaning filter device automation is high, pressure loss is small, and do not have to be manually removed filter residue. Now on the market most of the self-cleaning filter device in cleaning can be uninterrupted water supply, self-cleaning filter device for industry, agriculture, municipal, desalination process, such as separation and filtration. Secondly, when the drain valve is opened, the pressure difference between the internal water pressure of the filter device and the external atmosphere causes the suction pipe to produce strong suction, water flow from the filter screen to the inside reverse high-speed flow will be washed down the impurities into the sewage suction through the discharge valve discharge. The sucker is driven by a two-way motor with a screw mechanism and moves in a spiral motion at a fixed speed so that multiple suction nozzles can suck the entire inner surface of the filter screen. The process takes about half a minute. During the whole anti-cleaning process, the system flows continuously. The whole operation of the filter device is controlled by the program controller.

Finally, Warner small editor to introduce to you about the self-cleaning filter filter process, the media to be processed from the filter inlet into, and then from the inside to the outside through the filter, impurities larger than the mesh are trapped and accumulate on the inner surface of the mesh to form filter cakes, which also capture some of the finer impurities in the water. Self-cleaning process: the pressure difference switch continuously detects the pressure difference between inside and outside the filter screen. When the preset value is reached, a signal is transmitted to the control box to start the cleaning cycle. The cleaning mechanism of the filtering device is a spiral up-and-down suction device, which is a hollow structure, in its axis by a certain distance vertical uniform distribution of a number of suction pipes. The dirt absorber communicates with a discharge valve. After reading the above introduction you must understand why stainless steel wire mesh made into backwash equipment in this regard, at the same time stainless steel wire mesh products can also be processed according to the actual needs of the length of the required size. The article is based on stainless steel http://www.huanawl.com/ .