CN
Chemical fiber stainless steel melt filter use what should be noted: 1, the first thing to do is to Compressed air dewatering and deoiling treatment, so that its relative humidity control at 70% below; 2, the filter should be installed on the platform of the fermenter as far as possible, in order to avoid or reduce the influence on the filter core when the fermentation liquid backflow; 3, that is, before installing the special solvent filter core for chemical fiber, the impurities in the pipe must be blown out clean, this will be installed in time to be able to quickly install in; 4, is to note that we must be installed in the chemical fiber special solution filter must be handled gently, to prevent damage to the filter medium; 5, chemical fiber special solution filter, hand should be in the filter o-ring interface, to avoid damage to the filter media, 6, chemical fiber special melt filter in the filter seat before insertion, o-ring application of silicone oil lubrication, this reduces friction and allows for quick installation.
Chemical fiber stainless steel melt filter in the design of what precautions: 1) aperture: also into the micron grade, aperture defines you need to filter the media is how much 2) pressure drop: refers to liquid or gas flow filter pressure loss. You must determine your GE environment and provide it to the filter manufacturer. 3) temperature range: How High is the operating temperature of the filter element? The metal alloy you choose for the filter element must be able to withstand the operating temperature. 4) strength: acid-resistant sintered screen filter is the best choice for high strength requirements, another advantage is that they are in the forward or reverse flow of strength is the same. The practical advantages of high-temperature-resistant sintering screen filter cartridge 1, high temperature-resistant sintering screen filter tube high applicable temperature up to 800 ° C. The ordinary high-temperature filter is usually made, the high-temperature resistance is only 280 ° C, the high temperature will cause the filter bag thermal deformation, and then break and burn the bag. In order to make the temperature lower than 250 ° C, it is necessary to add a huge cooling system, which not only loses heat energy, but also makes the polymer oil liquid phase in the flue gas precipitate out and paste the bag, leading to the unavailability of the dust removal equipment.Therefore, high dust collector is the best choice for purifying high-temperature flue gas, it will not bend under high-temperature conditions, to ensure the stable operation of the dust removal system. Because of friction between the fabric and the Ca' d'Oro bracket, continuous stretching and smashing can cause premature damage to the fabric. Compared with the bag filter, especially under the high temperature condition, the service life of the high temperature dust collector is obviously prolonged. High temperature dust removal sintering mesh filter Jane is the core of the filter filter. It has good anti-high-temperature corrosion performance, back-blowing dust-cleaning performance, high porosity determines the small initial pressure drop, high filtration gas flow rate, solid structure makes it has a longer service life and so on. The total cost of bag filter is high because of its short life, high cost of supporting equipment, high operation and maintenance cost, and maintenance-induced shutdown. Because of the advantages of high-temperature dust collector, such as good filter material, simple equipment, long service life and no maintenance, the total dust removal cost is far lower than that of bag-type dust removal equipment.