CN
Speaking of high-temperature filter may have a lot of friends do not know, today Warner Small series for you to explain how to apply high-temperature filter at the same time what are the characteristics? The high temperature resistant filter is mainly used to make the evaporative screen of the parking heater filter of Bellevue Bridgestone. The main features of the product are as follows. 1: Parking Heater Evaporator Net is our company specially for Heilongjiang, Jilin, and Russia and other alpine regions of customer development of a new product. Its main feature is to save electricity, power consumption is only equal to the original with resistance heater about 1/4, which is a good solution to the car battery in winter when there are different degrees of power loss, can be very good to ensure the normal work of the heater, to ensure the normal start of the pre-heated starter; 2: The Machine's line connector with imported waterproof plug-in, very good to prevent the muddy road of mud, water splashing, it can prevent the corrosion of oil, eliminate the short circuit and open circuit, and greatly improve the life of heater。
3: Auto Oil Heater adopts automatic control, with high reliability and safety. With automatic temperature control more able, when the temperature of heated water (or antifreeze) reached 78 degrees, the machine automatically shut down; when the temperature dropped to 65 degrees below, as long as the switch is not off, you can automatically start again; 4: use the machine to warm up the engine, not only the antifreeze (circulating water) heating, but also the engine oil for moderate heating, making oil viscosity. Previous practice and test data show that the engine wear caused by a cold start is equivalent to the normal driving of a vehicle 200 km, and 60% of the engine wear is caused by cold start. Therefore, the installation of heater can fully protect the engine, extend the engine life of about 30% ; 5: parking heater evaporation network only used when the engine is preheated, preheating time according to the circulation of water diameter, it usually takes about 15-30 minutes. Its fuel consumption is limited, the economic cost is very low. Through the above introduction, I believe that we have a better understanding of how to apply high-temperature filter with the characteristics, I believe that high-temperature filter will provide more contributions to the progress of science and technology. The article is based on stainless steel http://www.huanawl.com/ .