About the working principle of stainless steel mesh applied in the filter and matters needing attention? Do you know about the stainless steel screen application in the filter? So today we mainly introduce the working principle of stainless steel mesh applied in the filter, stainless steel mesh applied in the filter filtration mechanism and operation precautions, you can understand.
Bag filter is a kind of multi-purpose filter equipment with novel structure, small size, simple and flexible operation, energy saving, high efficiency, closed work and strong applicability. Is a pressure type filter device, the main filter cylinder, cylinder lid and quick opening mechanism, stainless steel mesh to strengthen network main parts, such as the filtrate by filter shell side inlet tube into the screen, the screen itself is a device in strengthening a basket with netting on top, liquid penetrant fineness required for grades of filter that can obtain qualified filtrate, impurity particles blocked by screen. Stainless steel mesh applied in the filter to replace the filter is very convenient, the basic filter no material consumption.
2. The diameter of inlet and outlet flange is φ40-450mm, and the large flow of single machine is 90-1000m3/h. Can provide quick opening design, the filter screen is very convenient to replace. It is also suitable for the occasions where the filter screen is replaced only after a long time. Stainless steel mesh applied in the filter because of the large volume, heavy cover weight, a worker is difficult to operate, in this filter plus rocker device, can reduce labor costs, to meet customer requirements.
Three, stainless steel mesh applied in filter operation and precautions stainless steel mesh applied in filter operation is simple, use only the required fineness level of the mesh installed in the filter cylinder, check whether the O-ring seal is intact, and then screw the filter cylinder cover ring bolt, can be put to work. After the pump starts, the pressure gauge on the filter rises slightly, and the initial pressure is about 0.05mpa. With the extension of the service time, the filter residue in the cylinder gradually increases. When the pressure reaches 0.4mpa, the cylinder cover should be shut down and opened, and the residue left in the filter bag should be checked. The filter pressure is generally set to 0.1-0.3mpa, which can be adjusted through the return pipe or the return valve on the pump. Excessive filtration pressure will damage the filter screen and the protective screen, so special attention should be paid to it.
Articles from stainless steel wire mesh, http://www.huanawl.com/product/8621.html, the above is our stainless steel wire mesh used in the filter structure and the working principle, classification, stainless steel wire mesh application of bag filter in the filter operation and matters needing attention in the introduction, hope that through our introduction, Can help you.