CN
We may not know our stainless steel filter element filter is not very well, so next we will introduce to you about the stainless steel filter element filter in our life and its filtration process, I hope to help you.
[1] The filter element should have enough strength and will not be damaged by pressure. [2] Suitable for food, medicine, electronics, chemical, industrial wastewater and other industries. [3] It can meet the requirements of hydraulic system for filtration accuracy and prevent certain impurities from entering the system. [4] Easy to clean and replace. Installation essentials. [5] The flow capacity is large and the pressure loss is small.
Two, the filtration process of stainless steel filter element filter inside the bottom of the filter material can be filled with 0.15~0.4 meters high quartz sand absorption, as a support layer, quartz sand particles can be used 20-40 mm, quartz sand can be filled with 1.0-1.5 meters granular activated carbon as a filter layer. The loading thickness is generally 1000-2000mm. Before loading, the bottom filter material quartz sand should be tested for the stability of the solution, soaked for 24 hours, meet the following requirements: the increase of the full solid does not exceed 20mg/L. The increase in oxygen consumption does not exceed 10mg/L. After soaking in alkaline medium, the increase of silica does not exceed 10mg/L. Stainless steel filter element filter quartz sand washed clean into the equipment should be carefully cleaned, the water flow should be washed from the top down, dirty water from the lower discharge, until the water is clarified, and then loaded into the granular activated carbon filter material, and then cleaned, water flow from the bottom to the top rinse, dirty water from the upper discharge.
The function of stainless steel filter element filter is mainly to remove macromolecular organic matter, iron oxide, residual chlorine. This is because organic matter, residual chlorine, iron oxide is easy to make ion exchange resin poisoning, and residual chlorine, cationic surfactant will not only make resin poisoning, but also destroy the membrane structure, so that the reverse osmosis membrane failure.
The above is our application scope of stainless steel filter element filter and an introduction to the filtration process. I hope that through our introduction, we can bring you some help. At the same time, if you are using our device, then also need to pay attention to its protection. This article is from the stainless steel filter element filter manufacturer http://www.huanagl.com/. It is strictly prohibited to be reproduced without permission.