The daily use and maintenance method of 316 stainless steel filter element is introduced

As we all know, 316 stainless steel filter element has been a very common filter equipment in our life, and it will be so popular? Now let's take a look at the daily use and maintenance of 316 stainless steel filter element, maybe you can know. A daily use 1, 316 stainless steel material of the filter, the water turbidity, we need to pay attention to in using the equipment into the turbidity of water in the work can bring too many impurities, to filter the impurities are left in the filter layer, it is easy to jam the clearance and the surface of filter, the adsorption effect of block equipment, in the long term it will also cause aging and failure of active carbon. So 316 stainless steel material filter element water must control the turbidity of 5mg/L below. 2. Backwash cycle The backwash cycle of this device is one of the factors directly related to the quality of the filtration effect. If the backwash cycle is too short, it is a waste of backwash water. And the backwashing cycle is too long, it is easy to affect the effect of adsorption, so when the turbidity of the water is below 5mg/L, it is generally 4-5 days to backwash once. 3. Backwashing strength in the process of backwashing, the expansion rate of the filter layer has a certain impact on whether the washing is complete. If the expansion of the filter layer is too small, it will lead to the lower activated carbon can not be suspended, resulting in washing is not clean; And if the expansion is too large, it is easy to run carbon phenomenon. So when we use the general control of its expansion rate between 40- 50%. 4, backwash time when the expansion rate of the filter layer is 40-50%, backwash strength is 13-15L /(m2? S), the backwashing time is generally controlled in 8-10min. Two, 316 stainless steel material filter element daily maintenance 1, if it is under normal operation, it is best to maintain a daily backwash, the specific law is to decide according to the water quality of the raw water; 2, when using the pipe must be checked every day, whether leakage? Is the pressure normal? 3. Generally speaking, it is recommended that the softening material in the equipment be replaced every 8-12 months. This is our daily use and maintenance of 316 stainless steel filter element for you to make the introduction, although just some relatively simple knowledge, but for those who just contact with these equipment is still very useful. We believe that 316 stainless steel filter element will create more convenience for our life.