Some misunderstandings in the design of stainless steel filter element

If we do not have a good grasp of the performance and use skills of a device before use, then it is possible to have a lot of fault problems in use, and in order to avoid the use of stainless steel filter, the following problems are we need to pay attention to! Myth One: Only one filter is installed in a filtration system, and it is a high precision equipment can meet the purpose. In fact, such a view is wrong. Experience in actual use tells us that different filters are applicable to different occasions. In a relatively complex system, filters with different properties and functions can be organically combined to play a good role. Mistake two: the rated flow of stainless steel filter element is the actual flow of the system, so as long as the same amount of choice can be. In the actual application, we will find that the flow rate of the equipment will change at any time due to the difference in the temperature of the medium and the system. If the rated flow rate is selected, the resistance will increase when the viscosity of the system oil is slightly larger, which may lead to pollution and blockage of the equipment and affect the effect of filtration. Therefore, in the actual use, it is good to choose the actual flow rate than the rated flow of equipment. Myth 3: The higher the precision of the filter, the better. Although the choice of high precision filter can effectively control the pollution, but also to a large extent to improve the system manufacturing cost, but also shorten the service life of the filter element. Therefore, we only need to choose the equipment suitable for precision according to the requirements of cleanliness of the system, as well as the requirements of the pollution degree of the hydraulic system components on the oil and other factors. Mistake four: no matter what kind of filter can be reused after cleaning. Not exactly. No matter what kind of material or structure of the equipment, it will change the filtration gap of the filter material when it is washed. Even if the recovery of the material is good, the gap will be expanded in the long run. Therefore, it is necessary to clean the equipment according to the actual situation, and comply with the maximum cleaning limit. If it is reached, it is necessary to replace it in time. The article comes from stainless steel filter http://www.huanawl.com/.