After we usually use the motor for a long time, there will be a lot of dust on the filter cover outside, which needs to be cleaned up in time, otherwise it will seriously affect the heat dissipation function of the motor, seriously burn the motor and cause unnecessary losses, so what are the precautions for cleaning the filter cover used for motor protection? Let's take a look.
The cleaning of metal filter cover is very crucial, not only affects whether the metal can be used normally, but also relates to the protection of metal motor. So, how does the metal filter cover clean? Cleaning metal filter cover needs to pay attention to what problems? Below is the cleaning method of metal filter net cover and matters needing attention. Determine that the metal is in the power condition, open the dust collection bin, the air inlet filter net will be quietly extracted using water to wash the air inlet filter net clean, and then placed in a cool and ventilated place to dry; Then take out the air filter from the back of the metal and clean the dust; Do not use rubbing, kneading and other methods to prevent damage to the filter cover when cleaning the filter equipment back to its original position.
The metal filter cover can only be dried in the shade, and can not be ironed or blown or roasted in other ways. This is very simple to cause the deformation of the filter cover to ensure that the filter is installed back to the original place before the metal can be initiated, otherwise it will constitute motor defects. The cleaning operation of metal filter cover is relatively simple. It is best to clean and replace the filter cover on time to ensure the vacuuming effect of metal. But when it comes to vacuuming, of course, it is still better to remove dust from the center, and it is more convenient to use. The above is the motor protection with the filter cover cleaning precautions, I hope we can let the filter cover play an important role.