How is the stainless steel strainer made?

     With the development of economy, the edge stainless steel filter screen is used more and more widely in industry, such as in mechanical parts, aerospace parts, pharmaceutical industry, sewage filtration, etc. , can filter dust, powder, gas, oil, water, liquid medicine, chemicals and so on. So how is the edge of stainless steel filter is made out of it? Today in Anping, Warner Bros. . First: the material of the stainless steel filter screen: 1. Need to prepare is the wire Mesh, steel plate, aluminum plate, copper plate and so on. Copper Plate and aluminum plate have better ductility, the highest utilization rate. 2. The edge of stainless steel filter used in mechanical equipment: Mainly Punch. The metal plate and the stainless steel wire Mesh are pressed and formed by the pressure of the punch press. Next: The manufacture step of the stainless steel filter net of the wrapping edge: 1. The use of tons of smaller punch will be stainless steel wire Mesh Punch into small round, or small square. And other shaped pieces. 2. Punching Steel Plate (stainless steel plate, galvanized steel plate, aluminum plate, copper plate) , the metal plate stamping into the shape of a ring, and the closing. 3. Put the stamped stainless steel wire mesh into the ring. Four. Again on the ring press flat edge filter material surface dust and easy to remove dirt, you can use soap, weak detergent or warm water washing. Stainless Steel surface trademark, film, wash with warm water, weak detergent, adhesive ingredients, use alcohol or organic solvent (ether, benzene) scrub. The stainless steel surface is contaminated with grease, oil and lubricants. Clean with a soft cloth and then with a neutral detergent or an ammonia solution or special detergent. This is how the stainless steel filter edge is made, I believe that you have a more in-depth understanding of the general introduction of the above, more stainless steel filter content can be logged into the http://www.huanagl.com view.