What are the points for attention when selecting a filter cartridge?

A lot of people have seen the dust filter, so we know whether the dust filter used in the process of what are the points for attention? Here's a look at the details: 1. Adhesive adhesive, dust removal filter cartridge adhesive adhesive select special adhesive water, and enough glue injection, it is different from the filter core strength requirements are not too high, dust filter cartridge in the work will have 6 kg pulse cleaning pressure constantly through the cartridge, so bad adhesive or too little glue injection cartridge end cover easy to fall off. 2. End Caps and support mesh, end caps should be produced from 0.7-0.8 mm thick plates to increase the overall strength of the cartridge. Support Net is not sloppy, the same should be chosen 0.8 mm thick diamond-shaped support net to ensure that the filter will not be deflated when blowing back. 3. Understand the nature of the dust: ordinary dust, wet dust or flammable dust, filter media set then it is necessary to determine the number of folds in your filter or effective filter area, this will determine whether the air volume of the filter cartridge and the air volume of the entire dust collector are matched, otherwise either the dust collector is not good or the filter cartridge life is short. Four. Filter media, the key of the filter cartridge is the filter media, 240 grams of polyester long fiber filter media made in China is one of the filter media widely used in the dust removal industry, filter media should be used with caution, of course, can not be replaced by 220 grams or 200 grams, this will shorten the service life of the cartridge. Use to fix the paper fold and paper fold between the binding material selection thicker material, binding adhesive tape can not use ordinary hot-melt adhesive bonding, otherwise the filter will be blown up like a balloon. The above is the selection of dust filter cartridge matters of attention, hope to help you through the above introduction.